Please check the following steps carefully

  1. Check that the cables are connected to the projector and the computer/Splitter
    you will have one of the following 2 cables Most rooms have a VGA cables and most prefabs have a HDMI cable
                   

                    VGA                            HDMI


  2. Check that the projector is using the correct Input or source
    Please click the source or input button on the remote And select VGA1 if your room uses a VGA cable or select HDMI1 if your room uses a HDMI cable
    If you are lucky to have a Control box in your room for the projector (Manor Mills and Prefabs) then please click the button labelled PC

  3. If the above two steps have not worked then Hold down the windows key and press the P button on the keyboard
    A screen similar to the one on the left or below should be visible
    Please make sure to select Duplicate


  4. If the above has not solved your issue then please submit a ticket